ITECHWORLD

These are the items you require to assemble your dish.

Open the brown box and layout the parts.

Place arm on back of bracket, lining up the two holes.

Fit both screws and washers to the back of the arm, this will hold

the arm against the bracket.

Insert four round head screws through the inside of the bracket

and secure the four bolts to the ends.

Align the small metal bracket/clamp and insert the two long

screws through the back. Adjust according to pole diameter.

Attach the back bracket to the dish using four remaining round

headed screws and four bolts.

Attach the short hex-head m6*12 screw through the plastic

bracket into the arm.

Clamp your lnb between the plastic brackets and insert a screw on each side.

Place a bolt on the other end of the plastic bracket where the

screw comes out and tighten.

Slide the metal clamp over the pole and tigten the two screws

to secure.

Your dish is now complete and ready to align / tune.